- Description
Specifications
Any design, Any image,Any character or font.
AI / DXF / DWG / EPS / PDF / SKP files are preferable but we can help converting JPG or any image files format.
Electric heating takes approximately 30 minutesIt (depends on the size), then the temperature is stable. You can accelerate the warming gas burner, in which case it will take up to five minutes warming up.
Send me a message to discuss your design in detail!
The heating time depends on the size of the board. Heating time 10-40 minutes.
Upon request, I will prepare the item with the economic postage.
Elecric Handheld Tool Models for Branding:
Watage / Max Arena sq-in / Max Arena cm2
100W / 3,6 sq-in. / 16 cm2
200W / 5,5 sq-in. / 36 cm2
300W / 14,4 sq-in. / 100 cm2
500W / 25 sq-in. / 169 cm2
Instructions for Use:
When burning, adjust the temperature of the brass plate to the material into which you will burn / print. First, try the optimal set up on scrap material.
Please read the following instructions carefully.
--- The brass burning head cannot exceed a temperature of 500°C (932°F).
--- Once heated to the optimal temperature, disconnect the device from the electrical networks or turn the gas burner off.
--- Do not leave the heating turned on permanently!
--- We recommend using the Laser IR Infrared Digital Temperature Thermometer and check its temperature regularly.
--- Use protective gloves. There is a risk of getting burned.
--- Never leave the device unattended.
--- Use a non-flammable work mat.
.
If used incorrectly and if the instructions are not followed, we bear no responsibility for any possible damages caused to property or health injuries.